The production process of PET plastic sheets involves several processes: surface cleaning, drying, filter plate – same color production – same color – cleaning – painting – polishing – waxing – testing.
Under the same conditions, fruits and vegetables with the same thickness of 10MM have slightly higher surface area values, while plastic products with a thickness of 20MM have slightly higher surface area values.
Under different conditions, fruits and vegetables with the same thickness have slightly higher surface area values, and 20MM plastic products have a larger surface area. In order to reduce costs, some places such as pineapples and potatoes.
Generally, water-based coatings or adhesives are used for processing to compensate for more defects, such as mold, bubbles, cracking, residual activity, and dust, and to prevent surface paint from cracking. This type of mold is called “cracking”, such as oil stains, dust, various oils, and fats. Before painting, wipe it clean with a dry cloth.
The larger the surface area, the less attractive it is to apply it with hot hands, and the lack of contact with the oil-based surface after brushing makes it difficult to remove the surface.
Slowly, the larger the surface area, the larger the surface area in some places, and some people need to inspect it. The surface area has increased, and smooth primer is rarely applied now. There is open or dark water seeping into the wall on the surface of the primer. In general, the thickness of the wall needs to be higher than 130 millimeters, and some walls can reach this height. The depth of the back of the wall will also increase, and the primer will also be very deep. At this height of the wall, the pressure difference of the ordinary surface layer increases the pressure difference of the wall base. For boards of the same standard, the pressure difference will exceed 15mm, but the smoothness of the base layer is not strict enough.
● Clean and maintain the dirt method, and the area for removing and treating surface dirt, fingerprints, or oil stains should be clean to ensure the cleanliness and dryness of the walls in the future.
The oil stains or other grease substances on the boards around the wall should be cleaned up, and the dust and dirt on the wall surface, as well as the loose areas on the wall, should be cleaned up.
The strength of cracks/wall bottom plywood is greater than 100 mm, and maintaining it for outdoor use can improve the firmness and safety of the building.
After pasting the composite board, it should be installed immediately and the flatness of the wall should be checked with a 2m ruler, and a 3m ruler should be used to check. When the board joint is less than 4mm, an additional 3mm interval between adjacent board surfaces should be added.
● Install the anti magnification plate, using an electric hammer to control it from the bottom chamfer and 1m from both ends horizontally. After one over crushing and compaction, use a 30-50kg electric hammer to control it. After one over crushing and compaction, use a 30-40kg electric hammer to control it.
● According to the design drawings, position the measuring plates on each construction drawing, and then calculate the size to ensure that the setting out is correct and the position is consistent with the design.
